Posted on 2 Comments

Line Up Your Conditioner

No matter the conditioner the pin outline should be facing UP, and the gaps in the white marking, or sometimes it’s a half-moon, should line up. See pic.

2 thoughts on “Line Up Your Conditioner

  1. My first time here.

    I am interested and it is about time something like this has been built.
    Thanks

    I have been working with an ssr interface for hall sensor input and outputs to ignition and injectors. Looks real promising.

    I am having some luck with hall sensor ac volt through bridge rectifier to gate ssr.
    I have read in two places that arduino can work with dc rectified pulse signal just fine.
    From what I understand if I use a missing tooth set up the arduino can see the 0 v signal just fine.
    The question is:
    Can arduino see the 0v if the 5v is not square wave?
    I have a bench set up to test with a variable speed motor so I can read the volt and amp out put at different rpms from hall sensor. I can read the in put and the ssr out put. I can see the dc volt and the peak volts. All look safe for the arduino board.
    I know about the adc/vr boards and that they work great. Just looking at a different set up for fun and learning.
    Will this work with your shield?
    I know it will work on all out puts.
    But the what about the hall sensor dc rectified in put after going through an ssr??????
    I wish to use your board with many ssr interfaces.

    I hope I am clear with this as I am a new comer to electronics and to ecu’s in general.
    4 moths now.

    Thanks to all.

    Mark

    1. Hi Mark,

      I’m not sure how well that will work. If the 0-5v is not square, it will not treat the signal as high until it reaches some threshold. I would guess somewhere between 2.5-3v. A VR conditioner detects the zero crossing of the AC signal, which is well below the threshold. Experiment, have fun, that’s what we are all here doing in our own way. 🙂 Just be sure that before you try to make an engine run with it, that you have it well worked out, or the engine might not last long.

      Thanks, Weaver

Leave a Reply to wmarkel Cancel reply

Your email address will not be published. Required fields are marked *