DSC Dual Signal Conditioner (VR)

(5 customer reviews)




This dual channel signal conditioner uses special circuitry to accept almost any input signal and achieve a lower price point than other products. Includes on-board indicator LEDs. This unit is compatible with the Speeduino 0.3 and 0.4, and also the NO2C and UA4C designs by WTMtronics and well as many other boards with the same connection layout. It uses the same pin ordering as the jbperf 2.1 modules, and all known Speeduino units that accept a conditioner use the same layout. Which is shown here: https://wiki.speeduino.com/en/boards/VR_conditioner#alternative-uses

Header pins are included but not attached to save shipping costs.

Trigger MUST be set to falling edge with this conditioner.

The first production run of the conditioner had a trace that was somehow missing. It was replaced with jumper wire (as seen in the photo) before leaving our facility. The problem was corrected and later productions do NOT require this jumper wire.


Additional information

Weight .2 oz
Dimensions 3 × 3 × .25 in

5 reviews for DSC Dual Signal Conditioner (VR)

  1. danz

    can this be ordered with soldered pins?

    • Weaver

      If you order it with a ECU that is also getting assembly services then it will get soldered. Elsewise if you make a request on your order and do NOT select free shipping then we will solder it for you.

  2. Logan Keely (verified owner)

    good quality board, small form factor. oval shaped pin contacts ensure ease of soldering.

  3. Seth (verified owner)

    Works great, using it to take in VSS from a T5 transmission.

  4. Severin (verified owner)

    Works perfectly on my AM6 50cc bike with stock flywheel! Very accurate!

  5. Cameron Thomas (verified owner)

    Is the gap the notch I am Supposed to align with my board?

Only logged in customers who have purchased this product may leave a review.

You may also like…