Kraken

Description

A programmable computer with advanced and powerful options and configurations!
Full Stand alone motor control, It is programmed with TunerStudio.

Kraken Stand Alone Motor Controller with new 7x faster processor!!
Full sequential injection and ignition up to 8 cylinders (Possible to configure and reuse for more outputs)

The ECU comes ready to use VR (reluctant), Hall or Optical type CKP Sensor.
Consists of internal 4Bar MAP (up to 45psi)

• DBW Integrated Control
• 2X Knock sensor inputs
• VVT outputs by angle (12V)
• VR inputs with adjustable sensitivity per RPM

-16×16 3D fuel and ignition maps, with base of either TPS (Alpha-N) or MAP (Speed Density)
-Decimal resolution for Timing advance
-After Start Enrichment
-Rev limiting (Spark based, hard and soft)(flames, explosions)
-Cranking specific enrichment, dwell timing and advance
-General logging through TunerStudio
-High speed tooth logging
-TPS calibration through TunerStudio
-Sensor calibration through TunerStudio (Coolant, IAT and O2)
-Warm Up Enrichment (WUE)
-TPS based acceleration enrichment
-Knock inputs
-VR sensing with senstivity adjustment
-Fuel pump activation/deactivation (With priming)
-Air contitioner control basic
-General outputs control (main relay, aux relays)
-Alternator control
-Battery voltage compensation for dwell and injectors
-Modular wheel decoder support
-Closed/open loop boost control
-Closed/open loop VVT control
-Closed/open loop O2 control
-Several CAN funtions/protocols supported
-Deceleration fuel cut off (DFCO)
-Launch control

The kit includes:
Kraken ECU
1m 48-wire harness
USB Cable
Software and docs are downloaded from links on our help page

See pictures for IO table